Solar Powered Based Water Pumping System Using Perturb and Observation MPPT Technique


This paper focuses on solar photovoltaic(PV) water pumping system the use of perturb and observation maximum power point tracking(MPPT) method. This total system is divided into two stages. In the first stage, an arrangement of PV modules is made which is a combination of number PV cells in series or parallel to extract the solar energy and convert into electricity. To maximize the power output of PV module, perturb and observation (P&O) MPPT technique has been used.


In its second stage, direct torque and flux control(DTFC) with space vector modulation(SVM) is used to control switching pulses of the voltage source inverter(VSI). The speed of induction motor drive is controlled by DTFC technique. The total system is developed in MATLAB and outputs are noticed.


  1. Solar PV array
  2. MPPT
  3. P&O Algorithm
  4. DC-DC Boost converter
  6. Induction motor



 Fig-1: Solar Water Pumping System


Fig. 2. DC link voltage (output voltage of the boost converter)

Fig. 3. output waveform of IMD under no load

Fig. 4. Waveforms under loading condition


In this paper control methods which manage the flow rate of water supply of solar powered based water pumping systen using IMD is decorated. From the simulation results it can be concluded that this system has good work.


As per view of irrigation system , the SPV array has been operated under standard enviromental conditions. The system is operated on maximum power by using P&O MPPT algorithm. Water flow rate and stator current of motor is controlled by the speed PI controller.


 [1] U. Sharma, S. Kumar, and B. Singh, “Solar array fed water pumping system using induction motor drive,” 1st IEEE Int. Conf. Power Electron. Intell. Control Energy Syst. ICPEICES 2016, 2017.

[2] M. A. G. De Brito, L. P. Sampaio, L. G. Jr, G. A. Melo, and C. A. Canesin, “Comparative Analysis of MPPT Techniques for PV Applications,” pp. 99–104, 2011.

[3] D. P. Hohm, “Comparative Study of Maximum Power Point Tracking Algorithms Using an Experimental, Programmable, Maximum Power Point Tracking Test Bed,” 2000.

[4] S. Member, “A Comparative study of different MPPT techniques using different dc-dc converters in a standalone PV system,” pp. 1690–1695, 2016.

[5] Z. Ben Mahmoud, M. Ramouda, and A. Khedher, “A Comparative Study of Four Widely-Adopted MPPT Techniques for PV Power Systems,” no. 1, pp. 16–18, 2016.

Leave a Reply

Your email address will not be published.