This paper present Space Vector Pulse Width Modulation (SVPWM) method in detail and its implementation in MATLAB. work investigation of Sinusoidal Pulse Width Modulated and Space Vector Modulated Voltage Source Inverter (VSI) fed Induction Motor (1M) drive has done and their simulation results are compared with each other.
Also FFT analysis for Sinusoidal Pulse Width Modulated and Space Vector Pulse Width Modulated VSl fed 1M drive is done and compared with each other. 20 HP 1M is used. The study confirms that 1M gives improved work when it is fed from Space Vector Pulse Width Modulated VS1.
- Space Vector Pulse Width Modulation (SVPWM)
- Sinusoidal Pulse Width Modulation (SPWM)
- Two Level Voltage Source Inverter (VSI)
- Total Harmonic Distortion (THD)
- Three Phase Induction Motor (1M).
Figure 1. Block diagram of SVPWM
EXPECTED SIMULATION RESULTS
Figure 2. (a) Line to Line Voltage (Vab) of Space Vector Modulated VSI (b) Stator current (i,..) of IM (c) Electromagnetic Torque (Te) of IM (d) Rotor Speed (Nm) of 1M.
Figure 3 (a) Line to Line Voltage (Vab) of Sinusoidal Pulse Width Modulated VSI (b) Stator current (i,a) of IM ( c) Electromagnetic Torque (Te) of IM (d) Rotor Speed (Nm) of IM
Figure 4. FFT Analysis of Line to Line Voltage (Vab) of (a) Sinusoidal Pulse Width Modulated VSL (b) Space Vector Modulated VSL
The simulation study of SVPWM method was given and compared with SPWM method. It was found that by using SVPWM method, THD content present in inverter output voltage is less as compared with SPWM method. Table III shows that the utilization of DC bus is l3.55% more for SVPWM compared TO SPWM method. i. e. SVPWM method achieved a better utilization of DC bus as compared with SPWM method.
The work investigation of SPWM inverter and SVPWM inverter fed 1M drive was done. Table IV shows, in case of SVPWM increased rotor speed with reduced error band produce as compared with SPWM. Also settling time is less for SVPWM as compared with SPWM. It was conclude that results for SVPWM method are more convenient than SPWM method.
- W. Van der Broeck, H. C. Skudelny and G. V. Stanke, “Analysis and realization of a pulsewidth modulator based on voltage space vectors,” IEEE Trans. Ind. Applicat., vol. 24,no. I, pp. 142-150, Jan.lFeb. 1988.
- Fukuda, Y. Iwaji, and H. Hasegawa, “PWM technique for inverter with sinusoidal output current,” IEEE Trans. Power Electron., vol. 5, no. I, pp. 54-61, Jan. 1990.
- Kolar, H. Ertl, and F. C. Zach, “Inf1uence of the modulation method on the conduction and switching losses of a PWM converter system,” IEEE Trans. Ind. Application., vol. 27, no. 6, pp. 1063-1075, Nov.lDec. 1991.
- Joachim Holtz,. “Pulsewidth modulation – A survey,” IEEE Trans. on Ind. Electron, vol. 1, pp. 11-18, Dec. 1992.
- H. Kwon and B. D. Min, “A fully software-controlled PWM rectifier with current link,” IEEE Trans. Ind. Electron., vol. 40, no. 3, pp. 355-363, June 1993.