Design and Performance Analysis of Three-Phase Solar PV Integrated UPQC Readymade Electrical Projects

2016 IEEE

ABSTRACT: In this paper, the design and performance of a threephase solar PV (photovoltaic) integrated UPQC (PV-UPQC) are presented. The proposed system combines both the benefits of distributed generation and active power filtering. The shunt compensator of the PV-UPQC compensates for the load current harmonics and reactive power. The shunt compensator is also extracting maximum power from solar PV array by operating it at its maximum power point (MPP). The series compensator compensates for the grid side power quality problems such as grid voltage sags/swells by injecting appropriate voltage in phase with the grid voltage. The dynamic performance of the proposed system is simulated in Matlab-Simulink under a nonlinear load consisting of a bridge rectifier with voltage-fed load.


  1. Power Quality
  3. DVR
  4. UPQC
  5. Solar PV
  6. MPPT



Fig. 1. System Configuration PV-UPQC


 Fig. 2. Performance PV-UPQC at steady state condition

Fig. 3. PCC Voltage Harmonic Spectrum and THD

Fig. 4. Load Voltage Harmonic Spectrum and THD

Fig. 5. Load Current Harmonic Spectrum and THD

Fig. 6. Grid Current Harmonic Spectrum and THD

Fig. 7. Performance PV-UPQC at varying irradiation condition

Fig. 8. Performance of PV-UPQC under voltage sag and swell conditions


The dynamic performance of three-phase PV-UPQC has been analyzed under conditions of variable irradiation and grid voltage sags/swells. It is observed that PV-UPQC mitigates the harmonics caused by nonlinear and maintains the THD of grid voltage, load voltage and grid current under limits of IEEE-519 standard. The system is found to be stable under variation of irradiation from 1000𝑊/𝑚2 to 600𝑊/𝑚2. It can be seen that PV-UPQC is a good solution for modern distribution system by integrating distributed generation with power quality improvement.


[1] Y. Yang, P. Enjeti, F. Blaabjerg, and H. Wang, “Wide-scale adoption of photovoltaic energy: Grid code modifications are explored in the distribution grid,” IEEE Ind. Appl. Mag., vol. 21, no. 5, pp. 21–31, Sept 2015.

[2] B. Singh, A. Chandra and K. A. Haddad, Power Quality: Problems and Mitigation Techniques. London: Wiley, 2015.

[3] M. Bollen and I. Guo, Signal Processing of Power Quality Disturbances. Hoboken: Johm Wiley, 2006.

[4] P. Jayaprakash, B. Singh, D. Kothari, A. Chandra, and K. Al-Haddad, “Control of reduced-rating dynamic voltage restorer with a battery energy storage system,” IEEE Trans. Ind. Appl., vol. 50, no. 2, pp. 1295– 1303, March 2014.

[5] M. Badoni, A. Singh, and B. Singh, “Variable forgetting factor recursive least square control algorithm for DSTATCOM,” IEEE Trans. Power Del., vol. 30, no. 5, pp. 2353–2361, Oct 2015.

Leave a Reply

Your email address will not be published.