Power management in PV-battery-hydro based standalone microgrid

ABSTRACT:

This work deals with the frequency regulation, voltage regulation, power management and load levelling of solar photovoltaic (PV)-battery-hydro based microgrid (MG). In this MG, the battery capacity is reduced as compared to a system, where the battery is directly connected to the DC bus of the voltage source converter (VSC). A bidirectional DC–DC converter connects the battery to the DC bus and it controls the charging and discharging current of the battery. It also regulates the DC bus voltage of VSC, frequency and voltage of MG. The proposed system manages the power flow of different sources like hydro and solar PV array. However, the load levelling is managed through the battery. The battery with VSC absorbs the sudden load changes, resulting in rapid regulation of DC link voltage, frequency and voltage of MG. Therefore, the system voltage and frequency regulation allows the active power balance along with the auxiliary services such as reactive power support, source current harmonics mitigation and voltage harmonics reduction at the point of common interconnection. The experimental results under various steady state and dynamic conditions, exhibit the excellent performance of the proposed system and validate the design and control of proposed MG.

 SOFTWARE: MATLAB/SIMULINK

 CIRCUIT DIAGRAM:
Fig. 1 Microgrid Topology and MPPT Control

(a) Proposed PV-battery-hydro MG

 EXPECTED SIMULATION RESULTS

 

 Fig. 2 Dynamic performance of PV-battery-hydro based MG following by solar irradiance change

(a) vsab, isc, iLc and ivscc, (b) Vdc, Ipv, Vb and Ib, (c) vsab, isa, iLa and ivsca, (d) Vdc, Ipv, Vb and Ib

 

Fig. 3 Dynamic performance of hydro-battery-PV based MG under load perturbation

(a) vsab, isc, Ipv and ivscc, (b) Vdc, Ipv, Vb and Ib, (c) vsab, isc, Ipv and ivscc, (d) Vdc, Ipv, and Vb

CONCLUSION:

In the proposed MG, an integration of hydro with the battery, compensates the intermittent nature of PV array. The proposed system uses the hydro, solar PV and battery energy to feed the voltage (Vdc), solar array current (Ipv), battery voltage (Vb) and battery current (Ib). When the load is increased, the load demand exceeds the hydro generated power, since SEIG operates in constant power mode condition. This system has the capability to adjust the dynamical power sharing among the different RES depending on the availability of renewable energy and load  demand. A bidirectional converter controller has been successful to maintain DC-link voltage and the battery charging and discharging currents. Experimental results have validated the design and  control of the proposed system and the feasibility of it for rural area electrification.

REFERENCES:

[1] Ellabban, O., Abu-Rub, H., Blaabjerg, F.: ‘Renewable energy resources: current status, future prospects and technology’, Renew. Sustain. Energy Rev.,2014, 39, pp. 748–764

[2] Bull, S.R.: ‘Renewable energy today and tomorrow’, Proc. IEEE, 2001, 89  (8), pp. 1216–1226

[3] Malik, S.M., Ai, X., Sun, Y., et al.: ‘Voltage and frequency control strategies of hybrid AC/DC microgrid: a review’, IET Renew. Power Gener., 2017, 11, (2), pp. 303–313

[4] Kusakana, K.: ‘Optimal scheduled power flow for distributed photovoltaic/ wind/diesel generators with battery storage system’, IET Renew. Power  Gener., 2015, 9, (8), pp. 916–924

[5] Askarzadeh, A.: ‘Solution for sizing a PV/diesel HPGS for isolated sites’, IET Renew. Power Gener., 2017, 11, (1), pp. 143–151

 

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *